Sync 2 to Sync 3 no rear view camera

Hello,

I have a 2015 F-150 Lariat and I just swapped out a Sync 2 module for Sync 3. Everything seems to work except the rear view camera (worked on Sync 2). I’m wondering if I have an as built item wrong in the code or if I need to do another step to get it on. Camera is enabled in the as built.

When I go into reverse, I get a black screen with the “+” zoom button available and the parking sensor overlay on the right side and the “please check surroundings for safety” at the bottom but no image or lines.

Any help would be greatly appreciated!

You should check this thread → No RVC, 360 Camera, or heated/cooled seats after upgrade from sync 2 to 3

I think you will find relevant information.

I posted in the other thread:

No IPMB. Yours will connect directly to the APIM.

Two things to do:

  1. Perform the Local Network New Module Calibration.
  2. Make sure the RVC is correct in the asbuilt.

If this does not work, if you have FORScan, post your APIM asbuilt.

Closed due to no response