Bezel Diagnostics Sync3 3.4 on the table

how can i start Bezel Diagnostics on the table? Maybe hs-can command. I need it for touch-screen calibration. ore hs-can command to start screen calibration. UCDS (red china) in FF3 - Spec.procedures - Touch panel calibration after click sends "Diag - Ok. Touch panel calibration -init OK! But on sync3 screen calibration didnt starts.

SYNC Region: EU

Navigation Variant: Nav

Manufacturer Year: Pre MY20

Install Type: Retrofit

Old SYNC Version: 3.0.25306

New SYNC Version: 3.4.20220

Do you have a error message, if so what is it?

Update Method: CyanLabs Syn3 Updater

Syn3 Updater Version: 2.12.5

Syn3 Updater Documentation Read: yes

Syn3 Updater Log File


Sync 3 APIM Bench Test Project Completed - Ford / Discussion - CyanLabs Official Community