Hi,
i have here the Pictures
I have the same issue as well, Keen to get a solution
I don’t see how this would be a screen layout issue as the screens are the same size and everything works fine until it uses the rear camera.
Can I ask users with this issue to post this elsewhere as this topic is specifically for enabling Park assist.
1 Like
Go to this thread to discuss this, please…
What gives for news?
Getting close I think.
Button reacts normally, screen shows correct screen. The only thing to figure is for some reason the active park screen disappears after about 10 seconds.
Need to clear any dtc and do a couple of module resets to see if things come back to life and stay alive - otherwise still got to refine some programming.
Just finished on mine swapping Sync 1 to Sync 3. Had the same problem - Cancelled by Driver. Turned out that at least for me was showing when I was trying to get park out assist as well. Managed to get it working by putting 05 = Front/Rear PDC SAPP (EU Display) in 7D0-04-02: ##XX-## and the park assist setting in BCM with FOCCCUS to similar - “#59 park assist, front and rear with sapp”. My PAM is not programmable, no asbuilt in forscan.
Hi there,
have you some news?
Yes!!! Thanks! 
1 Like
If you have a Focus MK3 in the UK (probably other areas as well), the PAM AsBuilt cannot be changed. It is set at the factory and there is no AsBuilt to change. Whatever the module is set to is how it stays.
These usually start BM5T or DV4T on the part number.
You can use a MK3.5 module starting F1ET which is configurable but there are other issues with doing this.
2 Likes
Of course, I didn’t find this thread until I upgraded the firmware for the PAM for my 2013 Escape Titanium.
Just recently got the OBDLink EX and tried to update the firmware for the PAM. Flashing was successful but got the following error U2101 for the PAM, HCM, PSCM, IPC and BdyCM.
I reverted it back to the original firmware and it’s still giving that issue.
I also followed this thread and made sure the order is right as well on which one to flash and which order from the below link.
http://www.2gfusions.net/showthread.php?tid=6712
Should I pull the battery and see if that would resolve he issue?
Due to the DTCs, the parking aid is also stuck on off and I wasn’t able to turn it on.
Anyone have any ideas on what I can do?
Just wondering if anyone would be able to offer some pointers?
Anyone did this perpendicular upgrade on Ford Escape 2015 Titanium? I would like to do this on my Escape.
Thanks
I did a sync 2 to sync 3 upgrade but have problems with my reverse camera its not a genuine Ford one I have lost all on screen graphics and the park pilot in the right hand corner but the camera still works it’s on a 2016 mondeo mk5 any ideas?
This is most likely an asbuilt programming issue. Run the APIM Interrogator Tool and post the APIM asbuilt.
@Louage might have a thought on this…
1 Like
Something has changed with back up cameras in 21194 but we don’t know what. I’d recommend trying an old version than 21194 and see if this fixes the issue as a starter.
1 Like
Just had a look mine says build 19200 system updates 30:45:11:72:07:76 if that is any help is this version any good?